Shuangfei Talcum Powder Putty Laboratory Instruments & Equipment Shuangfei Talcum Powder Putty Laboratory Instruments & Equipment Hebi Biaochuang Instrument Manufacturing Co., Ltd.

Usage Method

1. Turn on the power switch of the analyzer and preheat for 30 minutes. Do not perform content measurement during this stage. When there is no "Preheating" prompt or "Sampling" prompt, sample measurement can proceed.

2. Weigh approximately 11.5g ± 0.1g of the sample, pour it into the mold, use a stirrer to level the sample, and place the mold rod to let it fall freely. Note: After the sample is poured, the steel ring must not move on the base block.

3. Carefully move the filled mold to the center of the tablet press work platform, press the plunger down to the bottom in one motion, wait for 10 seconds, then slowly retract the plunger. Remove the pressed sample and use a rubber bulb to blow dust off both sides. The pressed sample must not protrude from the steel ring surface, and there should be no cracks on the measured or back side.

4. First, enter the content measurement menu, place the sample to be measured into the slider, then push the slider all the way in (the words "Sample to be Measured" will appear in the lower right corner). Press the "1" key or "Start" to begin.

5. After measurement is complete, pull the slider out fully until "Hard Standard Sample" appears in the lower right corner, then remove the sample.

6. Press "0" to return to the content measurement menu.