Capacity: 240L (±5%); Weight: Single barrel body ≥6.8Kg, lid weight ≥1.1Kg, total weight with wheel axle ≥10.0Kg; Length*Width*Height (mm): Length ≥710mm; Width ≥585mm; Height ≥1000mm (including lid); Without lid ≥930mm; Rubber wheel: ф195*50mm, inner ring polyethylene, built-in steel sleeve, outer ring rubber wheel, weight ≥0.75KG; Steel axle specification: ф23.5*544mm. Weight: 0.3KG

2. Product Requirements:

(1) Appearance performance: The surface is smooth and flat, free from bubbles, ripples, impurities, sand holes, black spots, cracks. The color of the plastic garbage bin body and lid from the same batch should be consistent, and there should be no obvious deformation in the closing parts.

(2) The product is made from high-density polyethylene virgin material (HDPE) through one-time injection molding, with high-quality reinforcement and anti-UV agents added. The pigment content reaches 5%, ensuring bright colors that do not fade for a long time. The aging resistance of the barrel body should meet the requirements of GB/T 16422.2, with sufficient mechanical strength and good impact toughness.

(3) The four sides of the barrel body adopt a longitudinal concave design, making the barrel more flexible, with greater load-bearing capacity and more stable performance. At the same time, there are 4 longitudinal reinforcing ribs on each side of the top outer edge, with a rib thickness of not less than ≥6mm.

(5) The bottom can be equipped with 7 wear-resistant pins, with a peripheral frame design and radial pattern in the middle to enhance wear resistance and firmness.

(6) Both sides of the barrel body

(7) There are 12 reinforcing ribs around the barrel body

(8) There is a circumferential reinforcing rib at the bottom of the lid