Shandong Kaidi brand KD-L312 thermal oil furnace cleaner is a water-based thermal oil cleaning agent with strong penetration, dispersion, solubilization, and emulsification effects. It has excellent cleaning capabilities for oil stains and dirt, with superior degreasing and stain removal performance. It can remove 1-10mm thick thermal oil coke deposits, achieving a cleaning efficiency of over 90%. This product was awarded the gold medal at the 3rd Shandong Science and Technology Expo. During the cleaning of thermal oil furnaces, 0-3000g of thermal oil coke deposits with a thickness of 1-10mm can be observed on the furnace's filter. The waste thermal oil cleaning agent may contain 0.01%-1.5% thermal oil coke deposits. After cleaning, the color of the cleaning agent turns brownish-black.

Characteristics of Shandong Kaidi brand KD-L312 thermal oil furnace cleaner:

Appearance: Light yellow transparent liquid

pH value: 9.0–11.0 (5% stock solution)

Relative density: 1.00–1.10

Rust prevention performance [35±2°C RH (95±2)% 24h]: Cast iron ≤ Grade 1

Application scope of Shandong Kaidi brand KD-L312 thermal oil furnace cleaner:

Used for cleaning thermal oil furnaces widely employed in various industries (petroleum, chemical, textile, printing and dyeing, chemical fiber, plastic, building materials, heating) or heat exchange equipment using thermal oil as the working medium.

When cleaning the thermal oil furnace system, the following operating procedures should be observed:
1. Drain the old oil.

2. Open the operating valve to fill with clean water, use the heating furnace to raise the water temperature to 80°C ± 5°C, switch the relevant valves of each reactor in the system to ensure all parts of the system are circulated separately, and circulate for three hours.
3. Open all low-point drain valves in the system to discharge the water.

4. Add the cleaning agent, with the amount being 10% of the total circulating oil volume of the system. Start the circulation pump for circulation, use the heating furnace to heat the cleaning agent to 80°C ± 5°C, and ensure the entire cleaning process lasts no less than 12 hours.

5. Rinse ①: Fill the system with clean water, start the circulation pump for rinsing.
6. Rinse ②.
7. Rinse ③.

8. After draining, use compressed air to blow out any remaining water in the system until it is completely discharged.
9. Add new oil: Inject new thermal oil into the system.
10. Dehydration: The dehydration method is equivalent to the standard for dehydration before using a new system.

If you have product needs or questions, please call the Technical Center of Kaidi Technology Industrial Cleaning Division to request a cleaning plan and quotation. The manufacturer supplies directly to customer factories, specializing in industrial chemical cleaning for ten years, ensuring product quality and technical strength kdhgzjz!