Cleaning Conveyor Belt Device MH-1200 Belt Width Spray Cleaning Box

Instructions for Use of Conveyor Belt Cleaning Box Equipment

The conveyor belt cleaning box is a device used to remove adhered materials from the conveyor belt. It not only effectively cleans the belt but also dries it, reducing the impact of chemical reactions on the belt, thereby extending its service life.

Below are the instructions for using the conveyor belt cleaning box, compiled based on search results:

Cleaning Box Function Introduction

1. Belt Stabilization System

The cleaning box features a unique belt stabilization system that ensures the belt enters and exits the device smoothly.

2. Spray System

The cleaning box first softens and cleans the adhered materials on the conveyor belt, making it easier for the materials to proceed to the next process.

3. Cleaning System

After the materials are softened by the spray system, they enter a specially designed combination cleaner to remove stubborn materials first, followed by fine particles, maximizing the removal of adhered materials.

4. Drying System

Since the cleaning box operates with water, residual moisture may remain on the belt. The unique drying system of our cleaning box effectively removes this residual moisture, achieving a cleanliness level of over 85%.

5. Drainage System

The cleaning box's unique drainage system allows the removed materials to be smoothly discharged from the device to the designated location without causing ground pollution.

6. Control System

The control box enables fully automated operation of the device and synchronizes with the on-site conveyor belt system.

Components of the Cleaning Box

Cleaning box body, solenoid valve, filter, pressure pump, control box, connecting flanges (installation flange, drainage flange), and wiring.

Usage Steps

1. Preparation

Ensure all components are intact, check if the control box is functioning properly, and connect the power and water sources.

2. Starting the Device

Turn on the power switch, and the device will automatically enter standby mode.

3. Cleaning the Belt

When the conveyor belt starts operating, the cleaning device interlinks with the belt system and immediately begins working. First, the return belt above the cleaning machine is slowly pressed down by the automatic engagement/disengagement device, ensuring full contact between the belt surface and the water-spray softening roller and cleaning system blades. Next, the solenoid valve opens, and purified water is evenly sprayed onto the belt surface through nozzles, washing and softening the adhered materials. These materials are then gradually removed by the cleaning system blades to achieve a clean belt surface. The removed sludge and excess water are temporarily collected in the collection box below the device and then discharged at a fixed point by the spiral drainage system. When the conveyor belt stops, the cleaning system ends its operation, and the automatic engagement/disengagement device withdraws, returning the belt to its initial state.

4. Drying the Belt

The cleaning box's unique drying system effectively removes residual moisture from the belt, achieving a cleanliness level of over 85%.

5. Maintaining the Device

Regularly inspect and replace worn parts to maintain the device's optimal operating condition.

Precautions

·During use, pay attention to the maintenance and upkeep of the device. Clean impurities from the filter and nozzles promptly to ensure smooth water flow.

·If the device malfunctions, stop using it immediately and have it inspected and repaired by professionals.

The above are the basic instructions for using the conveyor belt cleaning box. Please note that specific operational details may vary depending on the device model and usage environment. It is recommended to read the device manual carefully before use and adhere to relevant safety operating procedures. Shandong Meihuan